Motorcycle Taillight Switches & Circuits
(Subscribe)
Report
Link
Rate It
Review It
Send To Friend!
Bookmark It
**FREE Tool Bar**
|
|
|
BRAKE LIGHT PULSATOR Causes the illumination of brake light to pulsate from bright to dim approx. 5 times per second Small (approx. 1" x 1-1/8" x 1-3/4") control module mounts easily in any convenient spot (including inside saddlebag or travel trunk) Increases bike's visibility and gives drivers behind you more time to react and stop safely Easy installation—requires cutting of brake light wire, installing terminals on cut ends and plugging in to pulsator. Circuitry is water and vibration resistant. Includes connectors and instructions. For 12-volt negative-ground systems. Note: Check local laws regarding legality of pulsating brake light.
$19.99
(Price
subject to change) |
|
Report
Link
Rate It
Review It
Send To Friend!
Bookmark It
**FREE Tool Bar**
|
|
|
STOP-ALERT BRAKE LIGHT PULSATOR Enhances illumination of brake light 100% solid state Quick and easy installation Connected in series with the third brake light of automobiles, and the stop lamp of motorcycles, to enhance awareness of stop lamp illumination. Each time the brakes of a vehicle are applied, the stop lamp flashes rapidly for a period of 5 seconds. If the brakes continue to be applied, the stop lamp remains illuminated until the brakes are released. Incandescent lamp power rating 60-Watts continuous, 120-Watts intermittent. Made of glass reinforced black Lexan plastic, epoxy encapsulated for protection against moisture and vibration. Termination is three 1/4" quick connect male terminals. Size: 1-3/4" x 7/8" x 1-1/8". Single hole mounting, or 2 hole panel mount available at extra cost. Operating temperature of -40°C to + 60°C (-40°F to + 140°F).
$25.99
(Price
subject to change) |
|
