Intake Manifolds
(Subscribe)
Report
Link
Rate It
Review It
Send To Friend!
Bookmark It
**FREE Tool Bar**
|
|
|
ACTION PLUS MANIFOLDS Improved design for increased power and better looks Fully CNC machined for a perfect fit Smoother, lighter and more consistent castings Made using the latest computer modeling and design technology, manifolds feature square bore carburetor flange, exhaust crossover and power band from idle to 5500 RPM. For Chevy small block 262-400 CID engines.
$269.99
(Price
subject to change) |
|
Report
Link
Rate It
Review It
Send To Friend!
Bookmark It
**FREE Tool Bar**
|
|
|
BILLET ALUMINUM INTAKE MANIFOLD CNC machined 6061 T6 billet aluminum head flange Machined intake runner surface reduces turbulence to increase speed & volumetric efficiency of intake manifold (70% over stock intake) Accepts throttle body up to 66mm. Can be used on naturally aspirated or forced-induction (turbo, etc.) car. 17"W x 10.25"H x 6"D.
$719.99
(Price
subject to change) |
|
Report
Link
Rate It
Review It
Send To Friend!
Bookmark It
**FREE Tool Bar**
|
|
|
INTAKE MANIFOLD Unlike all-out racing manifolds, this street performance manifold increases horsepower while maintaining good bottom-end power Range: 2000 to 8000 RPM Uses all factory sensors The ultimate street performance manifold! Similar to the popular JDM Type R manifold but with additional built-in improvements! Plenum chamber has been lengthened to provide extra plenum volume when used with your supercharger, turbo or nitrous setup…allows more flow for more horsepower. Nitrous bosses are located on underside of manifold. 65mm inlet can be bored larger if desired. Vacuum lines are relocated to back of engine for a clean under-hood look. Works with factory or aftermarket throttle body. For Acura and Honda with B16A Type "B18C-5" DOHC V-TEC engine. Not for use with GSR head.
$238.99
(Price
subject to change) |
|
Report
Link
Rate It
Review It
Send To Friend!
Bookmark It
**FREE Tool Bar**
|
|
|
OFFENHAUSER® HIGH-PERFORMANCE 4-BBL. INTAKE MANIFOLD Adds V8 power to your in-line 6-cylinder engine Lightweight cast aluminum manifold features an open plenum to boost engine breathing and dramatically improve low-end torque and performance from 2,500 through 7,000+ RPM. Allows installation of larger standard-bore 4-bbl. carburetor (sold separately). Includes installation kit. Note: Not legal for sale or use in California on 1966 and later registered motor vehicles. This product is intended for off-road or racing use only and is not intended or applicable for highway use.
$279.99
(Price
subject to change) |
|
